How to install the fixture with a peeling tester?

How to install the fixture with a peeling tester?

Dongguan Haida Instrument 400-071-1808/0769-89280808

In most cases, when the tensile testing machine is shipped, the manufacturer will remove the fixture. The main purpose of doing so is to be afraid of some external factors such as bumps, shaking, etc. during the transportation process, resulting in a specific collision testing machine. The fuselage, which causes damage to the casing and the subject of the tester, not only affects the appearance but also may have a certain influence on the tester data.

Therefore, when the customer receives the tensile tester, he or she will have to install the clip itself. So how does a tensile tester install a fixture to save energy? In fact, the specific installation of clips is not complicated, as long as you master the essentials and some tips, you can easily get. Here are the Xiaobian of Dongguan Haida Instrument Tester to explain these tips for you:

When the lower clamp is installed specifically, the lower joint and the lower clamp are specifically connected, and then the two are inserted into the guide bar and connected through the fixed pin. After the completion, the lock nut and the connection nut are tightened to eliminate the gap. Tensile testing machine measurement principle.

When the upper clamp is installed, first connect the universal joint to the upper connecting seat, then connect the two to the upper cross beam, then connect the upper clamp to the upper joint, and then connect the universal joint with the fixed pin. Tighten the lock nut.

Tip: Now let's tell everyone that one of the most labor-saving installations clips a specific method! The upper clamp is specifically placed on the lower clamp, and the middle cross beam is manually raised so that the upper clamp is specifically assembled with the universal joint. At this point, you should carefully move the middle beam so as not to damage the parts of the tester.